Maintenance method of spiral wound pipe machine parts

Spiral wound pipe machine is a full-plastic structure corrosion-resistant atmospheric storage tank manufactured by spiral extrusion winding technology. The structure of the spiral wound HDPE pipe machine is divided into two types: vertical and horizontal. Compared with the one-time molding process, the spiral extrusion winding technology has good strength and strong design. Next, let's take a look at the maintenance methods of spiral wound pipe machine parts. Here are some answers.

Here is the content list:

l Maintenance method of spiral wound pipe machine transmission case.

l How to maintain the gearbox and cooling water pipe of the spiral wound pipe machine.

Maintenance method of spiral wound pipe machine transmission case.

To protect the casing of the HDPE spiral tank transmission case, the following points must be achieved: after the first use of 500 hours, the lubricant should be replaced once. The oil level in normal operation shall not be lower than the centerline of the oil standard, please replenish it if it is lower than the centerline. The oil of the spiral wound pipe machine will be changed every 3000 hours after use. Clean the tank and filter once-dynamic the oil. Informative the grease used this point once dynamic, place the clean grease on the tank once more to scrub the tank once, then discharge it, and so install a brand new one. The grease filter ought to be clean each month throughout traditional use, and therefore the grease filter ought to be clean weekly throughout the running-in amount. To scrub up, realize the filter, open it, and take away the dirt.

How to maintain the gearbox and cooling water pipe of the spiral wound pipe machine.

The maintenance of the reducer of the spiral wound pipe machine is the same as that of the general standard reducer. Principally check the damage and failure of gears and bearings. The gearbox should use the lubricating oil specified in the machine manual, and add oil according to the specified oil level. If the oil is too little, the lubrication is insufficient, which reduces the service life of the parts. Excessive oil, high heat generation, high energy consumption, and easy deterioration of oil will also cause lubrication failure and cause damage to the parts. The oil leakage part of the reduction gearbox should be replaced in time to ensure the amount of lubricating oil.

In addition, the inner wall of the cooling water pipe attached to the spiral wound plastic pipe machine is prone to scale formation, and the outside is prone to corrosion and rust. Careful inspection should be done during maintenance. The excessive scale can block the pipeline and fail to attain the cooling impact. If the rust is serious, a water run can occur. Therefore, descaling and anti-corrosion cooling measures should be taken throughout maintenance. It's conjointly necessary to visualize the damage and phone of the brushes of the DC motor that drives the screw. Frequent mensuration of whether or not the insulation resistance price of the motor is on top of the required price ought to even be measured. Additionally, check whether or not the connecting wires and different components area unit rusty, and take protecting measures.

Our official website is https://www.krahpipe.net/. If you are engaged in work related to spiral-wound pipe machines or want to know more about our company, you can communicate with us on the website. Our company adheres to the service tenet of "customer first", and implements honesty and customer-first service.